Thanks Larry, I now have the freq set and I tried the power at 75 and it sent a short burst of RF which was picked up on a monitor but no APRS data. Same for setpower 75. Left it at 50. Will have to play around with these. Now all this has been done with the T2-301 connected to the PC. What do I have to do now to go operational. I have one of the Argent GPS units ready to connect to the radio but will no longer be able to configure the unit. Thanks to all of you for your help. You have walked me through a process that would have taken me forever to figure out on my on. 73, Joe
--- In [email protected], "k7ybz" <k7...@...> wrote: > > > By default the T2-301 is already set to 144.390 but here are the command > syntax's: > > SETFREQ ttt.ttt rrr.rrr - Sets the transmit and receive frequencies in MHz, > for example SETFREQ 144.390 144.390 to set transmit and receive both to > 144.39 MHz. (Note that the receive frequency echoed by the command may not be > what was entered; this is a minor glitch that will be fixed in future > versions.) > > SETPOWER pp - Sets the transmit power, from 0 to 99. The scale is non-linear > and varies with the supply voltage, and there is some variation from unit to > unit, but the following values are guidelines: > > The above was copied from the ArgentData WIKI: > http://wiki.argentdata.com/index.php/T2-301 > > And yes, DISPLAY should show all the settings. > > Larry > K7YBZ > > --- In [email protected], "Joe" <weewoods@> wrote: > > > > > > > > --- In [email protected], "Rudy" <benner@> wrote: > > > > > > SETPOWER and SETFREQ don't echo to the consol. > > > > > Do you have any idea what the syntax is for these commands. When I enter > > SETFREQ, I get "Error". Any other change to SETFREQ such as a ?, I get > > invalid command. Did not try SETPOWER. These don't appear to be normal > > TNC commands. Incidentally, doesn't DISPLAY produce ALL the commands in > > the TNC? > > > > Tnx, Joe > > >
