That is certainly an unusual effect if it is active in Celani's device.  We 
know that traveling wave tubes work with electrons and electromagnetic waves 
and ocean waves interact with the wind.


The concept of a shock wave allowing some form of energy reinforcement with the 
wire has interesting possibilities.  I wonder if the shape of the wave front 
impacting the potential outer tube microphones would reveal if something of 
this nature is occurring?  Your concept reminds me of the cone shaped pattern 
of a sonic boom.


I have been thinking that surface features from which the heat impulses 
originate are quite small in dimension and randomly distributed around the 
circumference of the wire.  Another concept would be to consider some form of 
mechanical resonant structure that depended upon the cross section area of the 
cylinder for ultrasonic reinforcement.  If we allow these ultrasonic resonances 
a whole new family of possibilities emerge.


Dave 



-----Original Message-----
From: Jones Beene <[email protected]>
To: vortex-l <[email protected]>
Sent: Mon, Oct 8, 2012 4:11 pm
Subject: RE: [Vo]:Progress from the Martin Fleischmann Memorial Project (Celani 
replication)


One further thought/speculation on this.

I was reading the other day that the “Light Gas Gun” which is a hypersonic
gun developed by the military, allows compressed hydrogen to produce
acceleration of about 5-6 km/sec. This is similar to the speed of sound in
nickel and about 4 times faster than the speed of sound in unpressurized
hydrogen. 

If one has a heated nickel wire in a pressurized H2 gas, and both have the
same (effective) speed of sound, but the gas in cooled at 90 degrees with a
radial vector to the outer wall, does this set the stage for some kind of
coherent wave effect, perhaps a travelling wave providing shock wave pulses
along the wire?

Given the size of Celani’s reactor, and compared to a resonance wavelength
of hydrogen, (mentioned below) … hmmm… looks pretty close to 2x wave, no?

IOW there could be a lot going on here, that even Celani did not realize…

                _____________________________________________
                
                FWIW: The Energetics Paper, recently discussed, shows the
“burst effect” from ultrasound in much greater emphasis. But we expect it
there. It is not impossible that ultrasound, or something akin to it, is
also involved in Celani, even though his experiment is gas phase. 

                There could be a surface effect on the charged wire - which
is similar to ultrasound. 

                Since there was no audible signature from the start
(apparently) there has been no reason for Celani to look for “inadvertent
ultrasound”, but … hey… it could be worth a look.

                According to Wiki: “Ultrasound devices operate with
frequencies from 20 kHz up to several gigahertz.” Kinda muddles the
distinction between RF and ultrasound, no?.

                Don’t forget the famous 21 cm line of hydrogen … It would be
within an ultrasound range, if Wiki is correct.


                                From: David Roberson .
                                
                                I find it intriguing that Celani's LENR
output seems to occur in the form of many individual bursts while most of my
earlier thoughts had been that the material behaved according to some larger
scaled system.  
                
                                

 

Reply via email to