Too many on ebay are garbage clones. So find a legit 5 volt one. You can wire rts to cts, etc. Aug AG5AT
Sent from my iPad > On Feb 8, 2021, at 3:30 PM, David Tiller <[email protected]> wrote: > > Also, the CP2012 is not 5v tolerant. > https://www.sparkfun.com/datasheets/IC/cp2102.pdf > >> On Feb 8, 2021, at 3:33 PM, Black Michael via wsjt-devel >> <[email protected]> wrote: >> >> Hmmm..that's 4-wire...so ground, tx, rx, and 5V and wouldn't work with >> hardware flow control. >> >> Mike W9MDB >> >> >> >> >> On Monday, February 8, 2021, 01:33:11 PM CST, August Treubig >> <[email protected]> wrote: >> >> >> A din 6 pin and this will work fine. >> >> https://www.adafruit.com/product/954 >> >> No magic. Just a bit of soldering. >> Aug >> AG5AT >> >> Sent from my iPad >> >>> On Feb 8, 2021, at 1:02 PM, Bill Somerville <[email protected]> wrote: >>> >> >>> >> >> Hi Mike, >> >> there are several third-party replacements for the now unavailable IF-232C >> module that is needed on this and other early Kenwood rigs. Most faithfully >> replicate the original IF-232C, some may not. The manual is almost certainly >> correct, the reporter, if he is correct, almost certainly has a non-standard >> IF-232C replacement. >> >> 73 >> Bill >> G4WJS. >> >> On 08/02/2021 18:17, Black Michael via wsjt-devel wrote: >>> The dude said "manual is wrong". >>> >>> Trying to get more information on serial cable to see if that's the cause. >>> >>> Old thread noticed a difference between cable types on a 450. Might have >>> to do with RTS/CTS wiring differences and whether the cable supports >>> hardware flow control. >>> >>> https://wsprnet.org/drupal/node/1307 >>> >>> Mike W9MDB >>> >>> >>> On Monday, February 8, 2021, 12:06:48 PM CST, Bill Somerville >>> <[email protected]> wrote: >>> >>> >>> On 08/02/2021 17:45, Black Michael via wsjt-devel wrote: >>> >>> > Anybody with a TS-450S out there that is available for some testing? >>> > >>> > I've got somebody claiming it needs 1 stop bit and XONXOFF handshake >>> > which I've never heard before and 2 stop bits and HARDWARE handshake >>> > is the default setup and has been for years. >>> > >>> > Mike W9MDB >>> >>> Mike, >>> >>> >>> according to the TS-450S/TS-690S CAT programming manual it is full >>> duplex 4800 baud 8N2 with RTS/CTS flow control using TTL signal levels. >>> I would be very surprised if that information was incorrect! >>> >>> 73 >>> Bill >>> G4WJS. >> >> _______________________________________________ >> wsjt-devel mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >> _______________________________________________ >> wsjt-devel mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >> _______________________________________________ >> wsjt-devel mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel > > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
