On 07/02/2021 17:14, Andy Stewart wrote:
I have been trying to report issues with xlog and hamlib-4.x for a
while now, but have problems with my mails being bounced, or ignored.
I find that if the hamlib model number is correct in the config file
then it works, but the the hamlib setup GUI dialogue displays the
model number minus one.
My correct radio is model 2003, which I have set manually in the
config file.
It shows in the GUI as 2002 but works.
Setting the radio model in the GUI puts 2003 in the GUI, but in the
config fle it is stored as 2004.
This needs sorting out.
Check what is in your config file!
Cheers,
Barry
G4MKT
Hi Barry,
I have never seen this issue of the model number being reported as -1.
Can you please describe the scenario precisely so I can duplicate it?
Please note that my email address has changed and *@mval.net will not work.
Thanks, and 73,
Andy
xlog maintainer
Hi Andy,
I hope you get this :)
No special steps to duplicate this - exactly as I described to Karsten.
If I put my correct Model ID for TS-450S in the config file as 2003 then
run xlog it works OK but the GUI in the Settings->Preferences->hamlib
dialogue shows model ID as 2002.
If I select the model using the GUI as TS450S then the model is shown in
the GUI as 2003, but in the config file it is stored as 2004 and does
not work.
If I select a TS-440S which is 2002 then it stores 2003 in the the
config and my TS-450S works fine!
I tried to send some links to lists of system component version numbers
etc. in the past but all these were bounced so I will leave it at this
for now, but please get back with anything that you need to debug this.
Sadly we are now in version freeze for Mageia 8 and this will have to be
dealt with as a bug report and update after release.
I was hoping to get a fix for this before now but all my attempts to
contact you failed.
Cheers,
Barry
G4MKT
(Mageia maintainer for xlog)