ons 2022-12-21 klockan 19:59 +0000 skrev andy pugh: > On Wed, 21 Dec 2022 at 19:54, Nicklas SB Karlsson <n...@nksb.eu> wrote: > > > Specify three points in 2D or 3D space: start, centre and end > > points as > > you suggest I think is a good idea that will work for an arc. > > That defines two possible arcs (simplistically, the short one and the > long one) > > > If I think correct it should be possible to program a foam cutter > > the > > same way as a 5-axis mill. A point on the wire is assumed to be the > > "tool tip" while kinematics solve the rest of the problem. > > It could be done, but the precision with which the A and B angles > would need to be specified would require a lot of places of decimals. > A floating point number have the same number significant digits wherever the decimal point is put so maybe not a big problem.
Then it should be one arc on top and anouther one on bottom? _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers