Am Wed, 5 Apr 2017 09:40:32 -0600 schrieb the...@sys-concept.com: > On 04/05/2017 08:14 AM, Daniel Frey wrote: > > On 04/04/2017 03:11 PM, Kai Krakow wrote: > >> > >> That's a good note. > >> > >> I think punch down is similar to LSA plus here in Germany, tho the > >> tools look very different. But with LSA you also push the wire > >> between to cutting contacts. > >> > > > > Yeah, it sounds like it works the same here: a wire is pushed > > through a V-bladed contact via a tool. > > > > Dan > > The problem with the cable was incorrect cross-over, the cable was > installed by a contractor few years back and terminated by them. > > When I initially tested the cable with cable tester one end was > connected to a switch I connected the tester to another and all the > lights were working in order. Wrong assumption. > The switch will respond to any ping and give a false readout.
May I suggest that you use the active part of the tester always on the side where the switch would be connected? This sorts out such problems. ;-) > I suppose to connect one end to transmitter and the other end to the > receiver (that came with it) and I've noticed incorrect order. > From Left: > Orange/White > Orange > Blue/Stripe > Blue > Green/Stripe > Green > Brown/Strip > Brown > > Re-termination fixed the problem. Good that you found it. Does it work correctly now? -- Regards, Kai Replies to list-only preferred.