Ali,
I see. So, you just need to go http://community.elphel.com/bootblock393/ again
and put the correct data to make 5MPx work. See the attached image.
In short - in the AUX Board table - make sure, *Application* field is *MT9P006
*, and the *Application mode* is *15 *. Then hit "PROGRAM AUX" -
Oleg,
Everything is OK with "14 Mpix" sensor; but when I connect the "5 Mpix" no
picture is seen at all. I'm sure that there is no problem with cable(it
works well with "14 Mpix" sensor ). The micro-SD card marked "5MPx" is also
insert to the slot too. I put the log files below.
And another
Ali,
1. Please send the /var/log/autocampars.log. It can help to rule out a
possible misconfiguration. If everything is correct then one can assume
it's a bad cable.
2. (just want to double check your configuration) Go
http://community.elphel.com/bootblock393/, make sure the ip address in the
Hello Ali,
There should be no problems with impedance matching, we tested both types of
sensors with up to 450mm cables (for ectremely long cable programmatic phase
adjustment may be needed). And the cables are the same for both serial (14MPix)
and parallel (5MPix).
Andrey
On Mon,
Hello Ali,
Can you 'ssh' to the camera? Could you send the /var/log/autocampars.log?
> ~$ ssh root@192.168.0.9
> ~# cat /var/log/autocampars.log
Or if you use minicom - send the boot log.
If I remember right you should have a microSD card marked a "5MPx" - the
camera autoboots from the card -
Hello
We have provided your product 10393. Your camera is very well designed and
made. Thank you for your good products and complete documentation and your
support.
Sensor installed on 10393 is a 14-megapixel sensor (10398) "mt9f002" by
default that Works well. We also bought the 10338 "mt9006"
