Does your site monitor show anything out of the ordinary? What are you
using to provide sync to the sync injector? The green lights on both
should blink once per second when they have sync.
On 11/28/2014 7:46 PM, Josh Luthman via Af wrote:
Here's a video, not sure what the blinking means?
https://www.youtube.com/watch?v=dME8A-H_590
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Fri, Nov 28, 2014 at 8:39 PM, Josh Luthman via Af <[email protected]
<mailto:[email protected]>> wrote:
*rb2011 with ports 2/3/4/5 set to hardware switch (ether2 master,
3/4/5 slave). Ports 6/7/8/9 are hardware switch (ether6 master,
7/8/9 slave).
*From the rb2011 it goes to the Ethernet half of the SyncInjector.
*From the POE half of the SyncInjector it goes to WB gigeapc HV
surge suppressors and then to the ePMP radios.
Two of the ePMP radios are powered up and running gige. Neither
are receiving CMM sync (top of the ePMP says "Not receiving GPS
sync"). The remaining 6 APs aren't even powering up/linking up.
Any ideas before I start swapping parts? Is it OK to have the
surge between SyncInjectors and ePMP?
On top of all of this the SiteMonitor isn't talking to the POE
injector or the two Gig SyncInjectors. I have them all daisy
chained and verified they're snapped in place. The POE injector
is powering Ubnt radios just fine.
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
