I did try a rescan sync twice on the SiteMonitor. I didn't see any change on anything - all devices (I could reach) stayed powered up. Always looked like this: http://imgur.com/ZlVE1tM
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Fri, Nov 28, 2014 at 9:13 PM, Nate Burke via Af <[email protected]> wrote: > Yes, sync pipe is required (or at least some external sync source). Have > you tried to rescan the bus from the sitemonitor? > > > On 11/28/2014 8:06 PM, Josh Luthman via Af wrote: > > SiteMonitor isn't showing any of the three expansion parts (poe injector > and 2x gig syncinjectors). > > Is a SyncPipe Basic required for the syncinjectors to work? Or do they > have an GPS radio? I'm not seeing any documentation saying it's necessary, > but it's mentioning it a lot... > > Will the gig syncinjectors still utilize 10 or 100 mbit? > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Fri, Nov 28, 2014 at 9:01 PM, Nate Burke via Af <[email protected]> wrote: > >> Does your site monitor show anything out of the ordinary? What are you >> using to provide sync to the sync injector? The green lights on both >> should blink once per second when they have sync. >> >> >> On 11/28/2014 7:46 PM, Josh Luthman via Af wrote: >> >> Here's a video, not sure what the blinking means? >> >> https://www.youtube.com/watch?v=dME8A-H_590 >> >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> On Fri, Nov 28, 2014 at 8:39 PM, Josh Luthman via Af <[email protected]> >> wrote: >> >>> *rb2011 with ports 2/3/4/5 set to hardware switch (ether2 master, 3/4/5 >>> slave). Ports 6/7/8/9 are hardware switch (ether6 master, 7/8/9 slave). >>> *From the rb2011 it goes to the Ethernet half of the SyncInjector. >>> *From the POE half of the SyncInjector it goes to WB gigeapc HV surge >>> suppressors and then to the ePMP radios. >>> >>> Two of the ePMP radios are powered up and running gige. Neither are >>> receiving CMM sync (top of the ePMP says "Not receiving GPS sync"). The >>> remaining 6 APs aren't even powering up/linking up. Any ideas before I >>> start swapping parts? Is it OK to have the surge between SyncInjectors and >>> ePMP? >>> >>> On top of all of this the SiteMonitor isn't talking to the POE >>> injector or the two Gig SyncInjectors. I have them all daisy chained and >>> verified they're snapped in place. The POE injector is powering Ubnt >>> radios just fine. >>> >>> Josh Luthman >>> Office: 937-552-2340 >>> Direct: 937-552-2343 >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >> >> >> > >
