Yes, this photo was just demonstrating how I was connecting the SyncPipe to the SyncInjector. I have a separate CAT5 with just Canopy-polarity power 27vdc (no data pins) going to the center port on the SyncPipe. Is this correct?
`S From: Af [mailto:[email protected]] On Behalf Of Josh Luthman Sent: Tuesday, December 29, 2015 16:45 To: [email protected] Subject: Re: [AFMUG] SyncInjector n00b question Syncpipe needs power. Up to 50v? Josh Luthman Office: 937-552-2340<tel:937-552-2340> Direct: 937-552-2343<tel:937-552-2343> 1100 Wayne St Suite 1337 Troy, OH 45373 On Dec 29, 2015 7:18 PM, "Scott Vander Dussen" <[email protected]<mailto:[email protected]>> wrote: Trying to use a SyncInjector to provide timing over power to a mix of 100/450APs. Gigabit SyncInjector revision I0, SyncPipe Deluxe revision H1 both receiving 27vdc. SyncPipe timing port directly to APs timing port works fine. SyncPipe timing port to SyncInjector “SyncPipe or Daisy Chain In” port does not seem to work. (see syncinjector.jpg) I’ve tried two SyncInjectors with the same results. If the SyncInjector is receiving sync from the SyncPipe, should I see the value column populated? (See site monitor string.png) Is there any configuration I need to change for the SyncInjector/SiteMonitor to make this combo work? Thanks in advance.
