Not sure... Does a light come on? Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Dec 29, 2015 7:51 PM, "Scott Vander Dussen" <[email protected]> wrote:
> Yes, this photo was just demonstrating how I was connecting the SyncPipe > to the SyncInjector. I have a separate CAT5 with just Canopy-polarity > power 27vdc (no data pins) going to the center port on the SyncPipe. Is > this correct? > > > > `S > > > > *From:* Af [mailto:[email protected]] *On Behalf Of *Josh Luthman > *Sent:* Tuesday, December 29, 2015 16:45 > *To:* [email protected] > *Subject:* Re: [AFMUG] SyncInjector n00b question > > > > Syncpipe needs power. Up to 50v? > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Dec 29, 2015 7:18 PM, "Scott Vander Dussen" <[email protected]> > wrote: > > Trying to use a SyncInjector to provide timing over power to a mix of > 100/450APs. > > > > Gigabit SyncInjector revision I0, SyncPipe Deluxe revision H1 both > receiving 27vdc. SyncPipe timing port directly to APs timing port works > fine. SyncPipe timing port to SyncInjector “SyncPipe or Daisy Chain In” > port does not seem to work. (see syncinjector.jpg) I’ve tried two > SyncInjectors with the same results. If the SyncInjector is receiving sync > from the SyncPipe, should I see the value column populated? (See site > monitor string.png) > > > > Is there any configuration I need to change for the > SyncInjector/SiteMonitor to make this combo work? Thanks in advance. > >
