I am useing Erics. thermocouple adapter with a type T thermocouple in the location of the grouphead bolt. The temp there is about 4 degrees F higher than where the water actually hits the puck (or Scace). With a blind basket in, the hot water will be @ around 125 psi coming out of the hole. I don't think a deflector cap would work . ----- Original Message ----- From: "cgfan" <[email protected]> To: "Brewtus" <[email protected]> Sent: Thursday, February 05, 2009 6:27 PM Subject: Re: Brew Temp problem on BII
> > Shaun, thanks for your input. You've left me with some other > alternatives to consider. > > One other method that comes to mind would be to place a blind filter > in the p/f and remove the allen wrench bolt on the "bridge of the > nose" of the E61 thermoblock. I can insert a probe in there, which > due to its location will probably reflect temps somewhat close to > brewing temp, though perhaps a bit higher. Of course it'll need a > little foil cap to act as a deflector to avoid brewing my face at the > SCAA recommended temps! > > --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/brewtus?hl=en -~----------~----~----~----~------~----~------~--~---
