so,,the routes clear now...bu when i make a sh plat tcam util on a 2960
it says alsways that tehere are 27/27 acl used...but there are no acls
configured/applied, I can´t find a good explaination for the output in
any command reference.
The only thing which i fond in all reference is something: Don´t use
that command, except Cisco TAC told you so.
Am 20.01.2011 19:07, schrieb Jose Madrid:
I have a 3560 and when do I "show platform tcam utilization" it says that I
have 1365 directly connected routes. This is definitely not the case and
when I do a "show ip route connected" there are various IP blocks shown, but
none longer than a /26 and maybe a total of 30 routes. Anyone know how
these numbers are computed?
#sh platform tcam utilization
CAM Utilization for ASIC# 0 Max Used
Masks/Values Masks/values
IPv4 unicast directly-connected routes: 2048/2048 1365/1365
IPv4 unicast indirectly-connected routes: 1024/1024 190/190
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
