We have an updated version ready.  You can update by just running
pcp-update pcp-sbpd.tcz

run sbpd --help to take a look at the command line changes for buttons. 
(The encoder stuff should not have changed)

PS.  Why are you using the 5v power rail for your encoder.  The rpi
inputs are only 3.3v.   Its much safer if you set the internal rpi
resistors to pull up, then wire your encoder to the zero volt, to pull
the inputs down to zero.

piCorePlayer a small player for the Raspberry Pi in RAM. 

Please 'donate'
if you like the piCorePlayer
paul-'s Profile:
View this thread:

diy mailing list

Reply via email to