I am trying to setup WSJT-X for JT65 operation on my K3 and Mac but can't seem
to get the program to work. My audio card is a SignaLink USB.
When I try to configure WSJT-X to interface to my K3, I always get the message
"Open Rig Failed".
Does anyone have any suggestions on the proper setup of the K3 as well as
WSJT-X?
Here is my K3 setup:
K3 CONFIG settings:
AF GAIN HI
AF LIM nor 030
LIN OUT nor 075
PTT--KEY OFF-OFF
RS232 38400 b
SPKRS 2
SPKR+PH NO
K3 MENU Settings:
MIC SEL Line In
MIC+LIN Not APPL (I can't change this)
Controls:
CMP 0
MIC MIC LINE 20
SQUELCH 0
RF GAIN 50%
MODE USB
NB OFF
NR OFF
NTCH OFF
VOX OFF
AGC AGC-F
ALT OFF
PWR 50 Watts
On the SignaLink USB I have the Tx and Rx gain set for 50% and DLY set to 0.
Thanks and 73,
Bob -
Bob Nobis - N7RJN
Goodyear, AZ
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
