Bob - have you modified the WSJT-X.ini file to point it to your SLUSB stuff? I had the same issue trying to get my iMac (and my MacBook Air) to properly do rig control. Here is what I had to do in my situation - your USBSERIAL name and location may be different:
CATdriver=/dev/cu.usbserial-A501XNHZ CATport=/dev/cu.usbserial-A501XNHZ Jim / W6JHB On Wednesday, Jan 29, 2014, at Wednesday, 9:06 AM, Robert Nobis wrote: > I am trying to setup WSJT-X for JT65 operation on my K3 and Mac but can't > seem to get the program to work. My audio card is a SignaLink USB. > > When I try to configure WSJT-X to interface to my K3, I always get the > message "Open Rig Failed". > > Does anyone have any suggestions on the proper setup of the K3 as well as > WSJT-X? > > Here is my K3 setup: > > K3 CONFIG settings: > AF GAIN HI > AF LIM nor 030 > LIN OUT nor 075 > PTT--KEY OFF-OFF > RS232 38400 b > SPKRS 2 > SPKR+PH NO > > K3 MENU Settings: > MIC SEL Line In > MIC+LIN Not APPL (I can't change this) > > Controls: > CMP 0 > MIC MIC LINE 20 > SQUELCH 0 > RF GAIN 50% > MODE USB > NB OFF > NR OFF > NTCH OFF > VOX OFF > AGC AGC-F > ALT OFF > PWR 50 Watts > > On the SignaLink USB I have the Tx and Rx gain set for 50% and DLY set to 0. > > Thanks and 73, > > Bob - > > Bob Nobis - N7RJN > Goodyear, AZ > [email protected] > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
