On Wed, 2008-04-02 at 11:06 -0700, Dave Engvall wrote: > For synergy users: (FYI) > > Gcode output from synergy defaults to a tool path at the tool radius > offset and then expects the tool table > to contain minor corrections from this. This scheme doesn't play well > with emc. > > However it is possible to generate zero offset paths in synergy; the ... snip
Thanks Dave. It's a bit of Greek to me right now, but should come in handy as I get up to speed. Is there an active forum or mail list to post Synergy questions? -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending Craftsman AA 109 restoration) ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
