John, I was going from the doc the first time and realized I missed a 10K, in measuring it, I see that it is in fact 20K. Everything off the P2 connector is identical since I connected to the other machine. I even went so far as to move the control panel so that I could use the same 6' cable used when tested against the other machine.
There were some minor changes to the I/O on P3, all of which is working. But I could try disconnecting that tomorrow to see if there is any way it could be making a difference. I will try your suggestions then too. Thanks, Eric My guess is that adding more power to the 5V rail won't make a huge difference. If a "supposedly identical" system works and this system doesn't, then they are NOT identical. Find the difference between the two systems and you will have found the answer. Maybe a wiring error, maybe the 10K isn't 10K on this system, any number of possibilities. Try the divide and conquer approach: Disconnect the entire external system and hook up a simple 10K load resistor. If that makes it droop, it is a board (or power) problem. If not, then it must be something about your external system. ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
