Not that I know of. dave On Apr 2, 2008, at 3:42 PM, Kirk Wallace wrote:
> On Wed, 2008-04-02 at 11:06 -0700, Dave Engvall wrote: >> For synergy users: (FYI) >> >> Gcode output from synergy defaults to a tool path at the tool radius >> offset and then expects the tool table >> to contain minor corrections from this. This scheme doesn't play well >> with emc. >> >> However it is possible to generate zero offset paths in synergy; the > ... snip > > Thanks Dave. It's a bit of Greek to me right now, but should come in > handy as I get up to speed. Is there an active forum or mail list to > post Synergy questions? > > -- > Kirk Wallace (California, USA > http://www.wallacecompany.com/machine_shop/ > Hardinge HNC lathe, > Bridgeport mill conversion, doing XY now, > Zubal lathe conversion pending > Craftsman AA 109 restoration) > > > ---------------------------------------------------------------------- > --- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/ > marketplace > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
