Hi all, I am getting a large voltage drop when I connect the analog outputs from the 7I33 to the load. With no load they show the correct voltages. The Mesa manual states "Due to power supply limitations, The 7I33 has limited DC output drive capability and should not have loads of less than 5K Ohms on its analog outputs."
The load is 10K, which seems to indicate that it should work. In fact I have had this hooked up to a supposedly identical system and it does work. My question is, if I add an Aux 5V supply (to 4 pin header P1) will that help with the DC output drive capacity of the Analogs? Thanks, Eric ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
