If I were to tap a hard plate I would reduce the thread depth by making the tap drilled hole a little larger.
On Nov 5, 2017 6:52 AM, "Mark" <[email protected]> wrote: > On 11/05/2017 05:07 AM, Gene Heskett wrote: > >> >> And where can I src from here in the US, a decent quality, 10mm 1.5 >> pitch, solid carbide spiral machine tap? Ebay's search engine and the >> sellers have no clue that there is a difference between HSS and carbide, >> using both words to describe the same item, nor what the difference is >> between a spiral tap and a spiral point. And neither do the sellers. :( >> >> Thanks guys. >> >> Cheers, Gene Heskett >> > https://www.mcmaster.com/ > > https://www.mscdirect.com/ > > If ya buy cheap Chinese crap, ya get cheap Chinese crap. > > Mark > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
