Kevin
 
I have no previous flight experience with Coupes even on the one we are talking 
about, I just bought the aircraft and engine sent for major overhaul to 
‘’LOMA’’ Belgium.
They did it along with all engine’s accessories including carburetor, changed 
magnetos to Slik and the crankshaft with a grinded one to 0,10.
The engine was braked in on a test bench and from my side for about 10 hours; 
compression checked and found perfect 80/80.
Rumors say that this airplane was running like that before overhauling but I 
can not verify that.
 
Kostas

--- Στις Κυρ., 16/11/08, ο/η kgassert <[EMAIL PROTECTED]> έγραψε:

Από: kgassert <[EMAIL PROTECTED]>
Θέμα: [ercoupe-tech] Re: Ercoupe flying in Greece
Προς: [email protected]
Ημερομηνία: Κυριακή, 16 Νοέμβριος 2008, 16:33






Kostas,

What sort of overhaul did you get? What are the compression check 
readings on the cylinders? I wonder if the rings are properly seated 
yet or the cylinder walls have glazed from improper seating. Did you 
have this airplane and fly it before the overhaul or did you just buy 
it? I ask this to verify that the performance change is due to only 
the engine overhaul. Continental spells out what carb jets should be 
installed so I would not go messing with the jets other then to 
verify that they are correct. Did this carb work OK before the 
overhaul? Was it overhauled with the engine? 

Kevin1
--- In ercoupe-tech@ yahoogroups. com, kostas vegas 
<constantinos16@ ...> wrote:
>
> Dear all good day
> Β 
> Hartmut was right for my carb heat. Finally flapper found stack in 
closed position.
> Rectified and now I can see a drop of 100 rpm on my tach.
> The issue is that Iβm still at the lowest side (2150 max) of the 
allowed static range 2110-2225 and on the air never exceed the 2350.
> During take off on a very nice day with only 18 C temp found very 
hard to climb out with two persons on board and limited fuel (my 
climbing rate was less than 300 fpm) and before reach 1500 feet we 
observed high lub oil temp (over 200F).
> My A&P insist that we are still suffering of poor mixture and he 
wants to change the main jet and nozzle with something bigger, any 
idea? 
> Β 
> Regards
> Konstantinos Tsgdis
> Athens Greece
> 
> 
> 
> ____________ _________ _________ _________ _________ _________ _ 
> Ξ§ΟΞ·ΟΞΉΞΌΞΏΟοιΡίΟΞ΅ Yahoo!; 
> Ξ'Ξ±ΟΡθΞ�ΞΊΞ±ΟΞ΅ ΟΞ± ΡνοΟληΟΞΉΞΊΞ¬ ΞΌΞ·Ξ½ΟΞΌΞ±ΟΞ± 
(spam); �ο Yahoo! Mail 
> διαθέΟΡι ΟΞ·Ξ½ ΞΊΞ±Ξ»ΟΟΞ΅ΟΞ· δυναΟΞ� 
ΟΟΞΏΟΟΞ±ΟΞ―Ξ± ΞΊΞ±ΟΞ¬ ΟΟΞ½ ΡνοΟληΟΞΉΞΊΟΞ½ 
> ΞΌΞ·Ξ½Ο…ΞΌΞ¬ΟΟΞ½ http://login. yahoo.com/ config/mail? .intl=gr
>

 














      
___________________________________________________________ 
Χρησιμοποιείτε Yahoo!; 
Βαρεθήκατε τα ενοχλητικά μηνύματα (spam); Το Yahoo! Mail 
διαθέτει την καλύτερη δυνατή προστασία κατά των ενοχλητικών 
μηνυμάτων http://login.yahoo.com/config/mail?.intl=gr 

Reply via email to