Hi Erich,
I am to trunk two interfaces 4/3 and 4/4 but on the trunk status still
the operational trunk capacity is 1G. Can you please help me further? I
could not get much information on the link you shared for the switch
type trunk for load balancing.
SI#show trunk
Configured trunks:
Trunk ID: 98
Type: Switch
Ports_Configured: 2
Primary Port Monitored: Jointly
Ports 4/3 4/4
Port Names none none
Port_Status enable enable
Monitor off off
Mirror Port N/A N/A
Monitor Dir N/A N/A
Operational trunks:
Trunk ID: 98
Type: Switch
Duplex: Full
Speed: 1G
Tag: No
Priority: level0
Active Ports: 2
Ports 4/3 4/4
Link_Status active active
Load Sharing
Mac Address 1 0
IP 0 0
IPX 0 0
Apple Talk 0 0
Multicast 0 0
Regards,
--------
Rupesh Basnet
On 03/28/2014 12:24 PM, Erich Hohermuth wrote:
Hi Rupesh,
I guess you hit the hardware limits when you try to build the primary
port 4/2 on this "old" foundry device.
<snip>
Each trunk group must start with a primary port. The primary port is
always the lowest number in the port range. For example, trunk groups on
a Chassis device can have the following primary ports:
2-port trunk groups: 1, 3, 5, 7, 9, 11,13, 15, 17, 19, 21, 23
</snip>
Also you can choose the the trunk type switch (default) or server which
influence the hash algorithm for the balancing. See below:
http://www.foundrynet.com/services/documentation/sribcg/current/Trunking.html
Regards
Erich
Am 27.03.14 18:44, schrieb Rupesh Basnet:
Hi All,
I have been trying LACP between Foundry and Linux machine since some
days but not able to figure out the issue and resolve the issue. I
didn't see much configurations thats needs to be done on foundry. I have
configured my linux box on mode 0 and bonding seems to be up but still I
am not able to pass traffic through it.
Serveriron Configurations:
interface ethernet 4/2
port-name **LACP-with-Linux***
no spanning-tree
link-aggregate active
!
interface ethernet 4/3
port-name **LACP-with-Linux***
no spanning-tree
link-aggregate active
!
SI#show version
SW: Version 09.3.00eTD4 Copyright (c) 1996-2003 Foundry Networks, Inc.
Compiled on Jun 28 2005 at 18:57:32 labeled as WXR09300e
HW: ServerIronGT E-2 Router, SYSIF version 21, Serial #: Non-exist
==========================================================================
SL 1: B0GMR WSM2 Management Module, SYSIF 2, M6, ACTIVE
Serial #: CH39040033
0 MB SHM, 2 Application Processors
16384 KB BRAM, SMC version 1, BM version 21
SW: (1)09.3.00eTF2 (2)09.3.00eTF2
==========================================================================
SL 4: J-BxGC16 JetCore Gig Copper Module, SYSIF 2
Serial #: CH33060779
4096 KB BRAM, JetCore ASIC IGC version 49, BIA version 8a
32768 KB PRAM and 2M-Bit*1 CAM for IGC 12, version 0449
32768 KB PRAM and 2M-Bit*1 CAM for IGC 13, version 0449
32768 KB PRAM and 2M-Bit*1 CAM for IGC 14, version 0449
32768 KB PRAM and 2M-Bit*1 CAM for IGC 15, version 0449
SI#show link-aggregate
System ID: 000c.db5d.b066
Long timeout: 90, default: 90
Short timeout: 3, default: 3
Port [Sys P] [Port P] [ Key ]
[Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
4/2 1 1 483 Yes S Agg Syn Col Dis Def No Ope
4/3 1 1 483 Yes S Agg Syn Col Dis Def No Ope
Status of linux machine:
MII Status: up
MII Polling Interval (ms): 30000
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:e0:ed:2b:a1:99
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:e0:ed:2b:a1:98
Slave queue ID: 0
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
