You might want to look at Gorilla Glue too. It foams up so it pushes into contours of the surface for maximum grip. Very useful. I suspect it's pretty much like liquid nails in other characteristics.
V> On Sun, 27 Aug 2017, 03:06 D.V.Rogers <[email protected]> wrote: > If your project is permament why not go Ferrocrete? > > https://en.wikipedia.org/wiki/Ferrocement > http://ferrocement.com/ > > You need the following; > Mortar Sprayer Oregon - http://www.mortarsprayer.com/ (you can also hand > trowel like stucco) > Permalath (BASF) - www.permalath.basf.com/ (or Chicken Wire) > > MIX: Three Sand to one Cement -3:1 Ratio > > *Portland Lime Cement Mix + Fibreglas Lathe Skin = 20year+ Hexayurt > > /dvr > > On Sun, Aug 27, 2017 at 2:18 AM, ken winston caine < > [email protected]> wrote: > >> Hunter: >> >> The "Fail" shown in the photos was with an unevenly broken polyiso board >> with quite ragged faces along the break. The successful followup test was >> done with clean-cut, smooth faces. That really does make a difference. But, >> still, you MUST clamp the repair, I have found. >> >> Unfortunately, I have quite a few small, ragged breaks that need to be >> repaired in my 40-some sheets of used polyiso. Continuing to work with >> Liquid Nails on those with less than ideal results. Liquid Nails works well >> on cleanly cut, smooth faces and spreads thinly with a putty knife (after >> laying out your zig-zag pattern of Liquid Nails). >> >> But, as mentioned in the "Fail" experiment, Liquid Nails does not "grab" >> and hold pieces together like a tacky adhesive would. You must apply the >> stuff to one surface -- spread it if you choose -- attach the pieces >> tightly and clamp them in place for 24 hours. >> >> UNRELATED CORRECTION: In the updated "success" test with Liquid Nails I >> said I would need to build 30-degree angle braces for clamping roof-cone >> pieces and (TYPO) 30-degree angle braces for clamping wall sections. It was >> supposed to say 60-degree angle braces for the wall sections. >> >> >>>> -- >> You received this message because you are subscribed to the Google Groups >> "hexayurt" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> To post to this group, send email to [email protected]. >> Visit this group at https://groups.google.com/group/hexayurt. >> For more options, visit https://groups.google.com/d/optout. >> > > -- You received this message because you are subscribed to the Google Groups "hexayurt" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/hexayurt. For more options, visit https://groups.google.com/d/optout.
