Greetings to all ! On our site we have installed a new TS3500 tape library. When we submit a backup job, the robot inside the library is not picking up the tape using the barcodes (As of now, we are manually moving the tapes to the drive). Also the drive is not ejecting the tape out(moving it to empty slot) after a successful read/write operation.
What could be the problem here ? FYKI : We are using 3592 JB tapes and the VOLSER reporting on the tape library is configured to 6 digits. All the tapes are initialized with six digit VOLSER. Thanks, Arun Chinnadurai **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS*** ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
