Hi Matt, I just checked the module with 10k pull up's on pin_d0 & pin_d1. Unfortunately I got no response on windows cmd screen. But I capture some events on WireShark ; The pic recognized as AsustekC_c6:53:16 It broadcasts on power-up with ARP 8 times It replies to ping requests from my PC(192.168.1.11), but it replies to 192.168.1.10 (which is not available on the network) with ICMP. Please send your comments, thank you
Kutsal On Jan 16, 8:44 pm, mattschinkel <[email protected]> wrote: > > I didn't connect the > > buttons on pin_d1 and pin_d0, but I think they have no effect on > > incoming ping requests, right? > > Actually this may affect your sample. Please at least put pull-up > resistors on pin_d1 and pin_d0. > > In the main loop, there is this, which could cause it to get stuck: > > while button == LOW loop > _usec_delay(100_000) > end loop > > The sample is tested and works, It looks like you have the same > module. You could also try installing Wireshark to see if you get any > data from 192.168.1.60 > > Also check that your network IP addresses are 192.168.1.xxx > > Try that first, if you still have trouble I can give you more > troubleshooting info. > > Matt. -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
