On 3/24/2020 10:44 AM, Dr. Feng Hsu wrote:
Yes Larry, it took me a day on researching and talking to local motor
cycle shops to found out the name for it (barrel adjusters)!
Dr. Hsu
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
As this is "experimental", I wonder if:
you can go with a totally different connector?, or
instead of using a bolt, drilling a hole down the center, and then
cutting a slot,
1. start with a length of threaded rod, correct diameter and thread size
2. spin a nut on each end just beyond the length required
3. use the nuts to hold the threaded rod in a vise
4. use a small dremel type tool to cut a slot in the rod to accept the
cable eliminating the need to center drill
Just wondering..............
Larry Flesner
_______________________________________________
Search the KRnet Archives at https://www.mail-archive.com/[email protected]/.
Please see LIST RULES and KRnet info at http://www.krnet.org/info.html.
see http://list.krnet.org/mailman/listinfo/krnet_list.krnet.org to change
options.
To UNsubscribe from KRnet, send a message to [email protected]
