This is what I ended up doing with my Hard Dog Hard Core Hard Top Double-Diagonal (HDHCHTDD) bar. It's slightly harder to climb in and out, but ultimately worth it, and my head isn't too close to the bar anymore.
2008/8/18 Shaun Bogan <[EMAIL PROTECTED]> > I've just decided to sit a bit more forward. It's not that uncomfortable > for the street, I'll just get used to it. > > > > Shaun > > > ------------------------------ > > *From:* [EMAIL PROTECTED] [mailto: > [EMAIL PROTECTED] *On Behalf Of *CB > *Sent:* Saturday, August 16, 2008 8:09 PM > *To:* [EMAIL PROTECTED]; 'Larry Alster' > *Cc:* 'Miata Power List' > *Subject:* RE: Hard Dog Hard Core fitment on MSM > > > > I for one am impressed.. > > > > CB&Stoker > > -----Original Message----- > *From:* [EMAIL PROTECTED] [mailto: > [EMAIL PROTECTED] Behalf Of *Brad Franks > *Sent:* Thursday, August 14, 2008 11:59 AM > *To:* Larry Alster > *Cc:* 'Miata Power List' > *Subject:* Re: Hard Dog Hard Core fitment on MSM > > I was going to flam this but I've decided to answer correctly. > > I was taught that seat position is determined by following two sequential > steps: > > 1. Adjust seat travel to the rear where when depressing the either the > clutch pedal or gas pedal completely your knee should bend no more than 75 > to 80 degrees (your knees should never lock when depressing a pedal). Adjust > to the longer reach. > > 2. After travel is adjusted set the seat recline so that the bottom of your > wrists land at the 12 o-oclock position on top of the wheel without your > elbows bent at 75 to 80 degrees (your elbows should never lock when turning > the wheel). > > With the seat adjusted in this manner my seat winds up one click from the > rear position and the seatback reclined to be flush against the bulkhead. > And this is with the seat back foam removed from my seat as well as about > half of the seat bottom foam removed as well. With stock foam in the seat my > head would rub against the top. > > When you are 6'4" every inch counts in a Miata. For a more accurate > description of what 6'4" is - I have a 36" inseam and wear a 36" shirt. > > Larry Alster wrote: > > Well since I donʼt really consider driving with the seat fully reclined in > a ghetto driving position to be proper driving posture I guess I never > considered this as restricting the travel of the seat. > > > > > _______________________________________________ > Miatapower mailing list > [email protected] > http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower > >
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
