This has happened several times and I found, by accident, that by
pressing the wires in back of the fuse box life comes back. It is time
to dig further into this problem and I am looking for some input as to
what might be the problem. About two years ago I replaced the fuse box
and ignition harness and made sure all the other connections were
clean and tight. I also went through the headlight bucket connections
to make sure they were all good. I am surprised that once the bike
comes back to life and runs, it does not stop or shut off for any
reason until I turn off the key, like it is not a broken wire. The
manual says under troubleshooting no power-key on it is a dead
battery, disconnected battery cable, main fuse burned out, or ignition
switch. Since I know the first three are not it, it leaves the switch.
Does anyone agree or is there something else I should look for? I also
see in the wiring diagram there is a " broken wire warning unit ".
Does anyone know where this is? Thanks for any help and ideas you
have. Wynn
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups
"Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/nighthawk_lovers?hl=en
-~----------~----~----~----~------~----~------~--~---
