In a message dated 2006-01-23 01:33:55 PM Eastern Standard Time, [EMAIL PROTECTED] writes:
> I also wish that component footprint drawings would measure from body > center to pad centers, rather than the pad edge-to-pad edge measures > that are the usual. > Personally I'd find center-to-center measures between pads to be more useful than either. But your suggestion is a huge improvement over the status quo. And I also want to see both component dimensions and recommended pad dimensions. That gives me a baseline, along with enough info to intelligently modify the baseline for a particular design, where the goal might be eas of hand assembly, or smallest possible overall size, or signal integrity issues, or.... Does anybody actually use those pad edge to pad edge dimensions?? Steve Hendrix ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
