Hi to all,
This question is more a general one,
I have to do a redesign of a 6 layer board. The layers sequence from top to
bottom is,
Top routing, second routing, GND, VCC, third routing, fourth routing.
Top layer has all IC's. The bottom layer has the resistors, cap aso.
If I change the GND and VCC to the top and bottom layer, there is more space
for routing.
Even more space I could get with the use of blind vias.
What does you mean is the better solution: six layer standard or 4 layer
with planes at top
and bottom and perhaps blind vias.
Georg Beckmann
[EMAIL PROTECTED]
###########################################
# BECKMANN+EGLE Industrieelektronik GmbH #
# Kirchstrasse 30, D-71394 Kernen-Stetten #
# Tel. +49-7151-949190, Fax: -47400 #
# --------------------------------------- #
# INTERNET: http://www.BuE.de #
# EMAIL (Beckmann): [EMAIL PROTECTED] #
# DURCHWAHL (Beckmann): 07151-94919-12 #
###########################################
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
