If you change to the violation tab under Browse PCB there should be a list
of violations and the location.
Another thing I do is change all to draft
"TOOLS>>PREFERENCES>>SHOW/HIDE/DRAFT" this allows me to see anything funny
going on with the pads or traces.
-----Original Message-----
From: TSListServer [mailto:[EMAIL PROTECTED]]On
Behalf Of Bryan Bernesi
Sent: Tuesday, February 27, 2001 11:42 AM
To: Multiple recipients of list proteledausers
Subject: Re: [PROTEL EDA USERS]: reconnecting nets
Thank you very, very much Colby. I was following the wrong steps before.
I still have not gotten a response from Protel Tech support..... but would
you know why my complete board would be lighting up with clearance
violations??? and how can I fix this problem without turning off the
clearance constraint rule, just in case there is a DRC....
Very kind regards,
Bryan Bernesi
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
