At 06:36 PM 2/18/2002 +0000, you wrote:
>As normal we load the gerbers back into protel to check they look right,
>I've noticed that
>the tented vias have solder on them on the paste mask.  Why, and how do I
>get rid of it?

(1) are you sure that they are vias and not free pads?
(2) what are the paste mask rule settings?

>We're just about to spin the boards and want to know if this will affect the
>mask manufacture.

Paste mask is typically the last operation which might or might not give 
you a little extra time. It might even be applied by the assembler as 
distinct from the board fabricator....

[EMAIL PROTECTED]
Abdulrahman Lomax
Easthampton, Massachusetts USA

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to