Ian Sorry to reply to myself but, after turning transparent layers on and off it now works correctly. Pads do display (if solder mask active) on top and bottom as expected in DXP. I don't know why they didn't before! Very strange.
-----Original Message----- From: Rich Thompson [mailto:[EMAIL PROTECTED]] Sent: 20 September 2002 06:37 To: 'Protel EDA Forum' Subject: Re: [PEDA] Selective tenting on one side only >snip< I just re-tried this on DXP, if I turn multilayer off, I don't seem to be able to see any evidence of pads at all. On 99SE at least you can fool it by turning holes, drill and solder/paster mask layers on. I have turned these layers on but I can only see the pads in multi layer mode. Am I missing something here? * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
