Dennis, Absolutely and I wish they would too, I was just taking the answer a little further with those outputs but many CAD systems do support slots why shouldn't Protel DXP.
Bob Wolfe ----- Original Message ----- From: "Dennis Saputelli" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Monday, October 13, 2003 11:17 AM Subject: Re: [PEDA] oblong Pads/Slots (plated) in P99SE > so protel could support proper slots if they chose to without > resorting to GenCam or ODB++ ? > > Dennis Saputelli > > > Edi Im Hof wrote: > > > > > > It does. > > The format is: > > > > XxxxxxYyyyyyG85XxxxxxYyyyyy > > X-Y Start X-Y End > > > > The code designations are: > > PSD: Plated, slot-drilled slots > > TSD: Tented, non plated and slot drilled slots, drilled in the same > > operation as the plated holes > > NSD: Nonplated, slot drilled slots, drilled in 2nd drilling operation > > > > Edi Im Hof > > > > <snip> > > > -- > Dennis Saputelli > > ========= send only plain text please! - no HTML ========== > _______________________________________________________________________ > Integrated Controls, Inc. www.integratedcontrolsinc.com > 2851 21st Street tel: 415-647-0480 > San Francisco, CA 94110 fax: 415-647-3003 > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *