I believe that If I remember correctly and I understand your question, all you need do is select to lock all pre routes and then run the autorouter.
----- Original Message ----- From: "Jim Labrecque" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Saturday, March 20, 2004 11:36 AM Subject: [PEDA] Advanced PCB / Advanced Route 3.0 > I realize I am using old software, but it is all I have on hand- > > Does anyone know whether it is possible to manually lay down some tracks > in Advanced PCB, and then have Advanced Route recognize these tracks > when you open the design? > > What I am trying to do is some incremental routes with advanced route- > > For example, the first routing I am trying is to have Advanced Route route > all of the voltage/gnds. This is a multilayer design with 4 planes consisting of > 3 voltage and 1 ground. > > I route the 3 voltages and grounds and then export the design back to Advanced > PCB for some cleanup- (ie shortening some of the stubs and adding additional > pads for connection into the plane on high current parts). > > I then save it so that I can import it back into Advanced Route and route the > rest of the signal tracks. > > However, after the design is loaded into Advanced Route, any additional tracks > or pads that I have added are not in the design- > > Anybody have any ideas or suggestions? > > Thanks, Jim > > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
