I remember that as being an issue in 2.8, but hey that a loong time ago and I'm not so young
----- Original Message ----- From: "matt" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Saturday, March 20, 2004 12:08 PM Subject: Re: [PEDA] Advanced PCB / Advanced Route 3.0 > wasn't there a bug in advanced route 3.0 which prevented this from working ? > I seem to recall (although not quite sure) some version having this problem > of ignoring the lock and routing from scratch everything no matter what had > been locked. > > > ----- Original Message ----- > From: "Joe Sapienza" <[EMAIL PROTECTED]> > To: "Protel EDA Forum" <[EMAIL PROTECTED]> > Sent: Saturday, March 20, 2004 11:47 AM > Subject: Re: [PEDA] Advanced PCB / Advanced Route 3.0 > > > > I believe that If I remember correctly and I understand your question, all > > you need do is select to lock all pre routes and then run the autorouter. > > > > > > ----- Original Message ----- > > From: "Jim Labrecque" <[EMAIL PROTECTED]> > > To: "Protel EDA Forum" <[EMAIL PROTECTED]> > > Sent: Saturday, March 20, 2004 11:36 AM > > Subject: [PEDA] Advanced PCB / Advanced Route 3.0 > > > > > > > I realize I am using old software, but it is all I have on hand- > > > > > > Does anyone know whether it is possible to manually lay down some tracks > > > in Advanced PCB, and then have Advanced Route recognize these tracks > > > when you open the design? > > > > > > What I am trying to do is some incremental routes with advanced route- > > > > > > For example, the first routing I am trying is to have Advanced Route > route > > > all of the voltage/gnds. This is a multilayer design with 4 planes > > consisting of > > > 3 voltage and 1 ground. > > > > > > I route the 3 voltages and grounds and then export the design back to > > Advanced > > > PCB for some cleanup- (ie shortening some of the stubs and adding > > additional > > > pads for connection into the plane on high current parts). > > > > > > I then save it so that I can import it back into Advanced Route and > route > > the > > > rest of the signal tracks. > > > > > > However, after the design is loaded into Advanced Route, any additional > > tracks > > > or pads that I have added are not in the design- > > > > > > Anybody have any ideas or suggestions? > > > > > > Thanks, Jim > > > > > > > > > > > > > > > > > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
