Looking at the pin side of the rj45 plug (not jack) 1- orange w/ stripe 2- orange 3- green w/ stripe 4- blue 5- blue w/ stripe 6- green 7- brown w/ stripe 8- brown
4 = Remote reset (short to ground for reset) 5 = Gnd 7,8 = Vcc + -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Aaron Bennett Sent: Saturday, October 25, 2003 1:14 AM To: [EMAIL PROTECTED] Subject: [smartBridges] Pins for PoE on AirBridge Outdoor Hi All, I'm new to this list, so hopefully it's the right place to ask.. If not, let me know; I won't take it personally. ;-) I recently was given an airBrige Outdoor with the external cable cut off to about an inch left out of the device.. I'm fairly familiar with wiring standard Cat5, but this will be my first attempt at re-wiring a PoE device. I've opened the device and am confident that I can splice on a new cable, and rewire it through the water seal. My question is what should the correct order be for the 8 wires in the cable? After 'extending' the cable, I will essentially be crimping on a rj45 head to attach to the powershot. Reading the back of the powershot device, I gather than pins 4 and 5 are negative, and 7 and 8 are positive.. Unfortunately, internally on the airBridge board, there is a blob of goo holding down the solder points for each colored wire... I can't tell which goes where. I've searched smartBridges website for pin-outs on the device, but no luck. If anyone has a device and can physically see what orders the wires are in, I'd appreciate it. Much thanks, Aaron Bennett [EMAIL PROTECTED] ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
