Hello Listers, I've resurrected a Adaptec 2930 CU SCSI card Slot#3 and installed into a S900, 9.2.2, IBM 20gig IDE (VST66) Slot#2, Yamaha 2100S CDRW (Bus3, ID#6) & Matshita CR-506 (Bus3 , ID#4) CD drives are both SCSI, Question is how do I know if their terminated properly? I "see" them both with SCSI Probe but I can not boot from either drive? I also have a SCSI Scanner attached to the external port which is terminated.so the question is "Do I need to terminate the internal drives" and by what method? "cable termination or jumper". The yamaha burner is at the end of the chain.
This SCSI stuff is confusing, I installed the Adaptec card only because I thought I'd get a little better preformance from it, rather then the internal MoBo. Can someone point me In the right direction, even suggestions on web info would be helpful. Thanks in advance, Phillip -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:supermacs@;mail.maclaunch.com> To unsubscribe, email: <mailto:supermacs-off@;mail.maclaunch.com> For digest mode, email: <mailto:supermacs-digest@;mail.maclaunch.com> Subscription questions: <mailto:listmom@;lemlists.com> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
