Hi,
anybody having some experience with this board..????
I have the following problem....after power on the board it does not output
any msg only if I use the " TrimbleStudio SMT " software......on my
PC......
Is there any solution to use the board without the PC/software ???????
Thanks a lot for any usefull advise.
Rgds Ernie.
_______________________________________________
Ernie,
I have one of these boards, and when I powered it up I got locked PPS
signals (albeit, quite narrow width). I didn't need to use any PC software
for this - no configuration was required. If you look back on the mailing
list messages, you may find a mention that the units recently on sale use a
Motorola protocol, not the Trimble protocol.
Cheers,
David
--
SatSignal Software - Quality software written to your requirements
Web: http://www.satsignal.eu
Email: [email protected]
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
