Hi David, thanks a lot for the info,.... I have also the 1PPS output, but had the impression that it will also output TSIP or any other kind of MSG upon power-up... and you can configure the board as required of the need.....it outputs according to the TrimbleStudio SW is TEP format but any interruption of the power / +3.3 V / then no any msg comes out..!!!! I want to use for the Brook Shera board....so the 1PPS is OK. I did not chked out with the Motorola software or TAC32 but will do.
Rgds Ernie. PS. for what board / gpsdo / do you use the SMT gps..???? -----Original Message----- From: David J Taylor <[email protected]> To: time-nuts <[email protected]> Sent: Mon, Jun 25, 2012 2:57 pm Subject: Re: [time-nuts] Trimble SMT board Hi, anybody having some experience with this board..???? have the following problem....after power on the board it does not output ny msg only if I use the " TrimbleStudio SMT " software......on my C...... s there any solution to use the board without the PC/software ??????? Thanks a lot for any usefull advise. Rgds Ernie. ______________________________________________ rnie, I have one of these boards, and when I powered it up I got locked PPS ignals (albeit, quite narrow width). I didn't need to use any PC software or this - no configuration was required. If you look back on the mailing ist messages, you may find a mention that the units recently on sale use a otorola protocol, not the Trimble protocol. Cheers, avid - atSignal Software - Quality software written to your requirements eb: http://www.satsignal.eu mail: [email protected] ______________________________________________ ime-nuts mailing list -- [email protected] o unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts nd follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
