Hi David, I have chked vith TAC32 SW, 9600 Baud and Motorola binary code and it is working OK. .... even will initialize the SMT gps board when there is a power interruption and no any protocol comes out. Also chked with the Winoncore SW and it display data but not all.. and this SW does not initialize the SMT board.
Of course and Trimble gps Studio is OK. Hope this helps a little. Rgds Ernie. -----Original Message----- From: David J Taylor <[email protected]> To: time-nuts <[email protected]> Sent: Mon, Jun 25, 2012 4:08 pm Subject: Re: [time-nuts] Trimble SMT board Hi David, thanks a lot for the info,.... I have also the 1PPS output, but had the mpression that it will also output TSIP or any other kind of MSG upon ower-up... and you can configure the board as required of the need.....it utputs according to the TrimbleStudio SW is TEP format but any nterruption of the power / +3.3 V / then no any msg comes out..!!!! want to use for the Brook Shera board....so the 1PPS is OK. did not chked out with the Motorola software or TAC32 but will do. Rgds Ernie. S. for what board / gpsdo / do you use the SMT gps..???? __________________________________________________ rnie, I will be interested to know whether the Motorola format works so look orward to your report back. I have no definite use for the board - it just ounded like a good buy. My interest is more in time than frequency, so I ould use it for PPS generation for NTP on a PC, with the Internet or other ervers providing the nearest second and the device providing the actual econd edge. Having seen how short the pulse is, though, I am uncertain hether it would work directly. I already have Garmin GPS 18 LVC, 18x LVC, nd Sure Electronics PPS sources, but having a third manufacturer (and one s highly rated as Trimble) can't be a bad thing. <G> There is also a remote possibility to use it in a stand-alone ulti-lateration device, although the non-standard output format could cupper that! It uses an older Trimble SMT board. http://www.modesbeast.com/radarcape-weblog.html Cheers, avid - atSignal Software - Quality software written to your requirements eb: http://www.satsignal.eu mail: [email protected] ______________________________________________ ime-nuts mailing list -- [email protected] o unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts nd follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
