Actually, I take that back about the Trango BHs. I forgot I ended up running fiber and direct DC to the Trangos. I have their rackmount -48v power supply (Duracomm rebranded I think). I was going to put positive on every pin but there was no way for negative to be isolated in my PRM24 rackmount APC surge deal.
On Fri, Apr 17, 2015 at 6:01 PM, Gino Villarini <[email protected]> wrote: > Details on trango.. Cause its –48 with pos on shield > > > > Gino A. Villarini > President > > From: Jeremy <[email protected]> > Reply-To: "[email protected]" <[email protected]> > Date: Friday, April 17, 2015 at 11:05 AM > To: "[email protected]" <[email protected]> > Subject: Re: [AFMUG] External POE. > > +1! I use them on every site that we have. I have powered AF, AF5X, > Trango licensed BHs, Gigabit Nanobeams, non-GB UBNT radios, cameras, you > name it! My favorite part about these is when I upgrade a radio from > 10/100 to Gb all I have to do is add a jumper. The boxes we build are > modular, and can be changed, upgraded, and expanded with very little work. > > On Fri, Apr 17, 2015 at 8:54 AM, Chuck McCown <[email protected]> wrote: > >> Yes. >> >> -----Original Message----- From: Matt >> Sent: Friday, April 17, 2015 8:51 AM >> To: [email protected] >> Subject: Re: [AFMUG] External POE. >> >> Tested with SAF? >> >> On Fri, Apr 17, 2015 at 9:41 AM, Chuck McCown <[email protected]> wrote: >> >>> So far, these have powered every device they have been called upon to do >>> if >>> it is GigE circuit. >>> Or a circuit with 802.1af type of wiring. >>> >>> http://www.wbmfg.com/products.cfm?PID=77&Cat= >>> http://www.wbmfg.com/products.cfm?PID=68&Cat= >>> >>> From: Mathew Howard >>> Sent: Thursday, April 16, 2015 5:42 PM >>> To: af >>> Subject: Re: [AFMUG] Packetflux Gigabit SyncInjector for 24 Volt Cambium >>> Radios - Ubnt too? >>> >>> If I remember right, the AF5x pinout is 1/2 & 4/5 positive and 3/6 & 7/8 >>> negative. >>> >>> Airmax stuff is all 4/5 positive and 7/8 negative, I imagine the 10/100 >>> stuff would work fine with the power pairs swapped, but I don't know what >>> that would do to gigabit. I don't think it's going to work with AF5x, >>> since >>> they use power on all four pairs. >>> >>> On Thu, Apr 16, 2015 at 6:19 PM, Josh Luthman < >>> [email protected]> >>> wrote: >>> >>>> >>>> I didn't check...sorry. It's on the roof so I can go up and look >>>> tomorrow. >>>> >>>> >>>> Josh Luthman >>>> Office: 937-552-2340 >>>> Direct: 937-552-2343 >>>> 1100 Wayne St >>>> Suite 1337 >>>> Troy, OH 45373 >>>> >>>> On Thu, Apr 16, 2015 at 7:14 PM, George Skorup (Cyber Broadcasting) >>>> <[email protected]> wrote: >>>> >>>>> >>>>> No pinout!? >>>>> >>>>> On 4/16/2015 6:10 PM, Josh Luthman wrote: >>>>> >>>>> It says 24v/1a and is gigabit. It is a bit different than the Nanobeam >>>>> POEs. It also doesn't work with an NSM5 for certain. >>>>> >>>>> >>>>> Josh Luthman >>>>> Office: 937-552-2340 >>>>> Direct: 937-552-2343 >>>>> 1100 Wayne St >>>>> Suite 1337 >>>>> Troy, OH 45373 >>>>> >>>>> On Thu, Apr 16, 2015 at 6:39 PM, George Skorup (Cyber Broadcasting) >>>>> <[email protected]> wrote: >>>>> >>>>>> >>>>>> What does the AF5x power supply say on the label for pairs or pinouts? >>>>>> Or is it the same as their other 24V/1A supplies, but gigabit? >>>>>> >>>>>> On 4/16/2015 5:29 PM, Josh Luthman wrote: >>>>>> >>>>>> I'm mostly concerned with the Ubnt Airmax stuff (24v) and AF5x. >>>>>> Obviously the ePMP works. >>>>>> >>>>>> >>>>>> Josh Luthman >>>>>> Office: 937-552-2340 >>>>>> Direct: 937-552-2343 >>>>>> 1100 Wayne St >>>>>> Suite 1337 >>>>>> Troy, OH 45373 >>>>>> >>>>>> On Thu, Apr 16, 2015 at 6:12 PM, George Skorup (Cyber Broadcasting) >>>>>> <[email protected]> wrote: >>>>>> >>>>>>> >>>>>>> AFAIK, the 450AP GigE interface is still powered only on pins 4, 5, >>>>>>> 7 & >>>>>>> 8. Probably applies to the ePMP Sync radio too. >>>>>>> >>>>>>> So, with that in mind.. does the UBNT GigE PoE stuff use all 4 pairs >>>>>>> for power? If it's 4, 5, 7 & 8, it may be possible, but... you'd >>>>>>> have to >>>>>>> flip the blues and browns at one end. I don't know what that would >>>>>>> do for >>>>>>> the GigE data interface though. It might not work. You can use a >>>>>>> 568B to >>>>>>> 568A (aka standard cross-over) cable and GigE still works fine, but >>>>>>> I'm not >>>>>>> sure about crossed blues and browns. >>>>>>> >>>>>>> Someone smarter than me would probably have to give you a thumbs up >>>>>>> or >>>>>>> down. >>>>>>> >>>>>>> >>>>>>> On 4/16/2015 4:55 PM, Josh Luthman wrote: >>>>>>> >>>>>>>> >>>>>>>> Has anyone tried these syncinjectors for Ubnt Airmax radios? What >>>>>>>> about anything else? I'd love to use this one product for all >>>>>>>> sites from >>>>>>>> now on. >>>>>>>> >>>>>>>> Is it possible to run the AF5x? >>>>>>>> >>>>>>>> Josh Luthman >>>>>>>> Office: 937-552-2340 >>>>>>>> Direct: 937-552-2343 >>>>>>>> 1100 Wayne St >>>>>>>> Suite 1337 >>>>>>>> Troy, OH 45373 >>>>>>>> >>>>>>> >>>>>>> >>>>>>> >>>>>> >>>>>> >>>>>> >>>>> >>>>> >>>>> >>>> >>> >>> >> >
