So far, these have powered every device they have been called upon to do if it is GigE circuit. Or a circuit with 802.1af type of wiring.
http://www.wbmfg.com/products.cfm?PID=77&Cat= http://www.wbmfg.com/products.cfm?PID=68&Cat= From: Mathew Howard Sent: Thursday, April 16, 2015 5:42 PM To: af Subject: Re: [AFMUG] Packetflux Gigabit SyncInjector for 24 Volt Cambium Radios - Ubnt too? If I remember right, the AF5x pinout is 1/2 & 4/5 positive and 3/6 & 7/8 negative. Airmax stuff is all 4/5 positive and 7/8 negative, I imagine the 10/100 stuff would work fine with the power pairs swapped, but I don't know what that would do to gigabit. I don't think it's going to work with AF5x, since they use power on all four pairs. On Thu, Apr 16, 2015 at 6:19 PM, Josh Luthman <[email protected]> wrote: I didn't check...sorry. It's on the roof so I can go up and look tomorrow. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Thu, Apr 16, 2015 at 7:14 PM, George Skorup (Cyber Broadcasting) <[email protected]> wrote: No pinout!? On 4/16/2015 6:10 PM, Josh Luthman wrote: It says 24v/1a and is gigabit. It is a bit different than the Nanobeam POEs. It also doesn't work with an NSM5 for certain. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Thu, Apr 16, 2015 at 6:39 PM, George Skorup (Cyber Broadcasting) <[email protected]> wrote: What does the AF5x power supply say on the label for pairs or pinouts? Or is it the same as their other 24V/1A supplies, but gigabit? On 4/16/2015 5:29 PM, Josh Luthman wrote: I'm mostly concerned with the Ubnt Airmax stuff (24v) and AF5x. Obviously the ePMP works. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Thu, Apr 16, 2015 at 6:12 PM, George Skorup (Cyber Broadcasting) <[email protected]> wrote: AFAIK, the 450AP GigE interface is still powered only on pins 4, 5, 7 & 8. Probably applies to the ePMP Sync radio too. So, with that in mind.. does the UBNT GigE PoE stuff use all 4 pairs for power? If it's 4, 5, 7 & 8, it may be possible, but... you'd have to flip the blues and browns at one end. I don't know what that would do for the GigE data interface though. It might not work. You can use a 568B to 568A (aka standard cross-over) cable and GigE still works fine, but I'm not sure about crossed blues and browns. Someone smarter than me would probably have to give you a thumbs up or down. On 4/16/2015 4:55 PM, Josh Luthman wrote: Has anyone tried these syncinjectors for Ubnt Airmax radios? What about anything else? I'd love to use this one product for all sites from now on. Is it possible to run the AF5x? Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373
