Tested with SAF?
On Fri, Apr 17, 2015 at 9:41 AM, Chuck McCown <[email protected]> wrote: > So far, these have powered every device they have been called upon to do if > it is GigE circuit. > Or a circuit with 802.1af type of wiring. > > http://www.wbmfg.com/products.cfm?PID=77&Cat= > http://www.wbmfg.com/products.cfm?PID=68&Cat= > > From: Mathew Howard > Sent: Thursday, April 16, 2015 5:42 PM > To: af > Subject: Re: [AFMUG] Packetflux Gigabit SyncInjector for 24 Volt Cambium > Radios - Ubnt too? > > If I remember right, the AF5x pinout is 1/2 & 4/5 positive and 3/6 & 7/8 > negative. > > Airmax stuff is all 4/5 positive and 7/8 negative, I imagine the 10/100 > stuff would work fine with the power pairs swapped, but I don't know what > that would do to gigabit. I don't think it's going to work with AF5x, since > they use power on all four pairs. > > On Thu, Apr 16, 2015 at 6:19 PM, Josh Luthman <[email protected]> > wrote: >> >> I didn't check...sorry. It's on the roof so I can go up and look >> tomorrow. >> >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> On Thu, Apr 16, 2015 at 7:14 PM, George Skorup (Cyber Broadcasting) >> <[email protected]> wrote: >>> >>> No pinout!? >>> >>> On 4/16/2015 6:10 PM, Josh Luthman wrote: >>> >>> It says 24v/1a and is gigabit. It is a bit different than the Nanobeam >>> POEs. It also doesn't work with an NSM5 for certain. >>> >>> >>> Josh Luthman >>> Office: 937-552-2340 >>> Direct: 937-552-2343 >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >>> On Thu, Apr 16, 2015 at 6:39 PM, George Skorup (Cyber Broadcasting) >>> <[email protected]> wrote: >>>> >>>> What does the AF5x power supply say on the label for pairs or pinouts? >>>> Or is it the same as their other 24V/1A supplies, but gigabit? >>>> >>>> On 4/16/2015 5:29 PM, Josh Luthman wrote: >>>> >>>> I'm mostly concerned with the Ubnt Airmax stuff (24v) and AF5x. >>>> Obviously the ePMP works. >>>> >>>> >>>> Josh Luthman >>>> Office: 937-552-2340 >>>> Direct: 937-552-2343 >>>> 1100 Wayne St >>>> Suite 1337 >>>> Troy, OH 45373 >>>> >>>> On Thu, Apr 16, 2015 at 6:12 PM, George Skorup (Cyber Broadcasting) >>>> <[email protected]> wrote: >>>>> >>>>> AFAIK, the 450AP GigE interface is still powered only on pins 4, 5, 7 & >>>>> 8. Probably applies to the ePMP Sync radio too. >>>>> >>>>> So, with that in mind.. does the UBNT GigE PoE stuff use all 4 pairs >>>>> for power? If it's 4, 5, 7 & 8, it may be possible, but... you'd have to >>>>> flip the blues and browns at one end. I don't know what that would do for >>>>> the GigE data interface though. It might not work. You can use a 568B to >>>>> 568A (aka standard cross-over) cable and GigE still works fine, but I'm >>>>> not >>>>> sure about crossed blues and browns. >>>>> >>>>> Someone smarter than me would probably have to give you a thumbs up or >>>>> down. >>>>> >>>>> >>>>> On 4/16/2015 4:55 PM, Josh Luthman wrote: >>>>>> >>>>>> Has anyone tried these syncinjectors for Ubnt Airmax radios? What >>>>>> about anything else? I'd love to use this one product for all sites from >>>>>> now on. >>>>>> >>>>>> Is it possible to run the AF5x? >>>>>> >>>>>> Josh Luthman >>>>>> Office: 937-552-2340 >>>>>> Direct: 937-552-2343 >>>>>> 1100 Wayne St >>>>>> Suite 1337 >>>>>> Troy, OH 45373 >>>>> >>>>> >>>> >>>> >>>> >>> >>> >>> >> > >
