Hi Tom, I had a cycling problem with my bilge switch as well...it would take forever to switch off. It finally fried itself after a season. When I installed my new one (different make and directly on the bottom the bilge like you did), I had the same problem! But then I played with the angle of the pump and set it so that the float end of the pump was slightly higher than the pump end. This will give you a clean shut-off. I just used a shim under the pump base to achieve this.
Mike C&C 33 mk II Toronto Sent wirelessly from my BlackBerry device on the Bell network. Envoyé sans fil par mon terminal mobile BlackBerry sur le réseau de Bell. _______________________________________________ This List is provided by the C&C Photo Album Email address: [email protected] To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
