Richard I tried using DATA-A as you advised: /"With the K3 in DATA A, check that MAIN:MIC SEL is set to LINE IN (this is remembered per-mode, so this won't upset your SSB settings), then use the K3's MIC control to adjust the Line In level. Put the K3's meter in ALC mode and adjust the Line In level so that the ALC meter reads 4-5 bars on an idling PSK31 signal. Use the PWR control to set power (use no more than 50 watts for good linearity). The settings that work in DATA A for PSK31 will also work in AFSK A for RTTY, except that you don't need to worry about non-linearity and you can run the power up to 100 watts for RTTY. / 73, Rich VE3KI
However whilst MVARI in N1MM decodes PSK31 signals fine, when i try to transmit I get no power output & instead I get a couple of error messages on the K3 - Error PTT , Error KEY which in the K3 manual saysits usually caused by an external device (the MicroHAM MKII?) shorting KEY or PTT to ground. I've obviously got something setup wrong in either N1MM config or in the MKII router. Any ideas please? Ray, G3XLG ----- Ray G3XLG -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-a-few-new-user-questions-tp7348177p7351795.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
