does it still crash without any external device powered up? (I too have been running linuxcnc up to 2.6.7 without issue)
sam On 05/17/2015 04:35 PM, Gene Heskett wrote: > On Sunday 17 May 2015 17:25:07 andy pugh wrote: >> On 17 May 2015 at 22:19, Gene Heskett <[email protected]> wrote: >>> Since I am software stepping, when I next reboot >>> it, I will raise the base_thread to 30 u-secs just for S&G's. I >>> believe it was 27 the last time I checked. >> Have a look at Machine->Show Hal Config and at the bottom of the list >> is "threads" >> >> Make sure that the base-thread time is less than the base-thread >> period by some margin. >> Also, make sure that only functions that need to be in the base thread >> are in the base thread. That is probably only parport.write, >> stepconf.make-steps and encoder.count > Printed for on site checking, thanks Andy. > > Cheers, Gene Heskett ------------------------------------------------------------------------------ One dashboard for servers and applications across Physical-Virtual-Cloud Widest out-of-the-box monitoring support with 50+ applications Performance metrics, stats and reports that give you Actionable Insights Deep dive visibility with transaction tracing using APM Insight. http://ad.doubleclick.net/ddm/clk/290420510;117567292;y _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
