> > > ... > > > The stuff here? > > > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?HalSchematicsUsingGschem > > ... > ... > Are you intending to be able to translate an existing, working config > into this, and to be able to take this back to working .ini + .hal > files?
No translation of existing config is planned because I expect it would be hard to place the symbols and nets. It should be used to make configuration file. it should probably be rather straight forward to implement feedback of attribute values if there is a use for it. > Not necessarily the originals, but perhaps order optimized that still do > the exact same job? That would, I believe, make logic mistakes in the > original .hal easier to spot. Face-palm moments, those. :-) I anyone who make circuit boards by writing the netlist and feed it into the layout program. As is now the *.hal file is almost only about connecting the pins. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
