On 03/14/2018 03:16 PM, Gene Heskett wrote:
A Halmeter question - is it possible to run multiple instances of
halmeter so that I can observe different pin's values and compare,
say, the original Z position, the offset, and the final Z position
after the offset is applied? That would be handy to make sure I've
got the negative values correctly and also to see if the hal code is
actually doing what I want it to do.
Yes you can Mark, the only limit I am aware of is screen real estate to
display them. Just pull down the menu and click halmeter to start
another.
Oh goodie! That's what I was hoping. I hadn't tried it yet, only using
a single instance.
Andy helped me out with a bunch of this stuff so some of it's copied
and pasted from his emails with minor edits to get the correct axis
numbers. In light of the top part of this email, is this correct? Did
I leave anything out? Is anything superflous?
I'll leave that last to Andy.
Who's been a great help! I really do appreciate the knowledge on this
list, and the willingness to help others. You guys are a godsend to
those of us who occasionally try to stumble through this stuff. Andy
especially and a number of others who have helped along the way.
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
